SXKT Restart Checklist After Storage

This guide turns that instruction into a practical owner-facing sequence. It is written for the SXKT-001 smart bioethanol fireplace family. Always match the advice to the rating label, order configuration and installation documents supplied with the actual unit.

Why a stored fireplace needs a deliberate return

Storage can introduce simple but important changes: a protective sheet may still cover a vent, packaging may have shifted into an airflow path, a cable may have been pinched, or dust may have collected around a burner outlet. None of those conditions should be “tested” with ignition.

The SXKT is a real-flame appliance that heats ethanol to create vapour and then ignites it. Its panel, remote and app make operation convenient, but they do not replace the physical inspection that should happen after a long idle period.

The six-stage SXKT restart walk-through

1. Establish a cold, safe starting state

Make sure the fireplace is not burning and no residual flame remains. Before cleaning, filling or draining, the appliance must be below 40°C; never touch the panel to judge temperature. If fuel remained in the unit during storage, follow SXFireplace’s instructions for removal and storage preparation rather than tilting or dismantling the fireplace.

2. Remove every temporary cover

Take away dust covers, protective film and any stored object around the installation. Look along the burner outlets, top-panel vents, cooling openings and the ventilation route beneath the unit. The path should be genuinely open—not merely provided on a drawing and then blocked by stored material.

3. Inspect what you can see without opening the appliance

4. Clean only the permitted surfaces

After shutdown, full extinction, cooling and power isolation, wipe the surface with a clean, slightly damp soft cloth. Keep water and cleaner out of the unit. Do not spray-wash, scrape with blades or metal tools, push hard objects into the combustion passage, or bend the flame sensor and ignition electrode.

Finish-specific care matters. The manual limits use of the supplied finishing cloth to suitable brushed stainless-steel surfaces and after-sales guidance; the same abrasive approach should not be used on titanium-plated, powder-coated or other coated finishes.

5. Reset the operating context

Before filling or ignition, confirm that thermostat and timer tasks are off unless you intentionally need them. A thermostat pause can be followed by automatic reignition, so “no flame right now” is not proof that the appliance has been shut down. Make sure a working local stop control is available even if you normally use the app.

If filling is required, use only 95% ethanol fireplace fuel and the IN port. Supervise the hose and container, allow the automatic full-level stop to work, then prevent drips and refit the cap. Do not pour fuel directly into the burner trough.

6. Observe the first complete cycle

Disconnect filling equipment, remove the fuel container from the flame area and confirm the panel is dry. Send one start command, then wait for the appliance response. Normal vapour preparation takes approximately 3–15 minutes depending on ambient conditions. Stay present while the flame develops, and observe the display, fan, flame line and surrounding installation.

At the end of the test, use normal stop and remain present until the residual flame has fully disappeared. Do not treat the screen status or elapsed time as proof that the burner is cool.

Do not repeatedly cycle power, retry ignition or enter test menus to clear a fault. Internal pumps, heaters, temperature sensors, wiring, smart-home connections and level calibration are service work—not routine cleaning.

What to record before contacting SXFireplace

A useful service request includes the sales model and serial number, shipment or order reference, fuel concentration, the exact operating step, the full voice/display message and clear photos or video. Never recreate a leak or failed ignition simply to capture footage.

our SXKT function guide